加拿大原型产地矿物种名称的中文译名     

杨主明  傅小土 《岩石矿物学杂志》2011,30(4):734-738

加拿大原型产地的矿物种数计208种,其中118个是具有人名或地名意义的矿物种名。这些矿物的现中文译名多数采用化学成分名称,未能体现原作者的意愿,与IMA-CNMNC关于新矿物的命名原则和译名规则不相符合。本文根据英文的人名与地名,采用音译方法,列举这些矿物的英文名称、原命名依据和现中文译名,并列出新的建议中文译名。  相似文献   

Refractor velocity analysis: a signal processing procedure     

Roberto de Franco 《Geophysical Prospecting》2011,59(3):432-454

This paper presents a signal processing procedure to perform refractor velocity analysis. The procedure enables one to obtain the seismic velocity from the refracted wavefield without the picking of refracted arrival times. Two processing procedures are derived, one starting from a seismic interferometric approach and another, from the conventional reciprocal method and generalized reciprocal method approaches. The theoretical equivalence of the two approaches is also demonstrated. The proposed processing procedure is applied to synthetic data in order to test the influence of some procedural parameters and its capability to reconstruct a known velocity model starting from refracted signals, without and with perturbations, in arrival times and noise; finally, it is applied to a field data set.  相似文献   

Tall building vibration control using a TM‐MR damper assembly: Experimental results and implementation     

Rene Zemp  Juan C. de la Llera  Paul Roschke 《地震工程与结构动力学》2011,40(3):257-271

This paper summarizes the relevant results of the design, construction, testing, and implementation of a nominal 120 kN magnetorheological damper developed to control a free‐plan tall building in Santiago, Chile, equipped with two 160‐ton tuned masses. Cyclic as well as hybrid simulation tests were performed on the prototype damper. Global building responses using measured MR properties showed good correlation with analytical estimations. Also, a proposed physical controller for the MR damper was validated through hybrid and building pull‐back tests. Its performance is essentially equivalent to that of an LQR controller, but the information needed in its implementation is considerably less. Pull‐back tests of 10 cm amplitude were performed on one mass along the flexible edge of the building and its response controlled using the passive and controlled modes of the MR damper. The MR damper was capable of controlling the TM displacements very effectively, as well as the simulated building response for different ground motions and harmonic excitation. Copyright © 2010 John Wiley & Sons, Ltd.  相似文献   

Tall building vibration control using a TM‐MR damper assembly     

Rene Zemp  Juan C. de la Llera  José L. Almazán 《地震工程与结构动力学》2011,40(3):339-354

  相似文献   

Evaluating restoration of man‐made slopes: a threshold approach balancing vegetation and rill erosion     

Mariano Moreno‐de las Heras  Rubén Díaz‐Sierra  José M. Nicolau  Miguel A. Zavala 《地球表面变化过程与地形》2011,36(10):1367-1377

The management of reclaimed slopes derived from industrial and civil activities (e.g. surface mining and road construction) requires the development of practical stability analysis approaches that integrate the processes and mechanisms that rule the dynamics of these ubiquitous emerging ecosystems. This work describes a new modelling approach focused on stability analysis of water‐limited reclaimed slopes, where interactive relationships between rill erosion and vegetation regulate ecosystem stability. Our framework reproduces two main groups of possible trends along the temporal evolution of reclaimed slopes: successful trends, characterized by widespread vegetation development and the effective control of rill erosion processes; and gullying trends, characterized by the progressive loss of vegetation and a sharp logistic increase in erosion rates. Furthermore, this analytical approach allows the determination of threshold values for the state variables (i.e. vegetation cover and rill erosion) that drive the system's stability, facilitating the identification of critical situations that require specific human intervention (e.g. revegetation or, in very problematic cases, revegetation combined with rill network destruction) to ensure the long‐term sustainability of the restored ecosystem. The application of our threshold analysis framework in Mediterranean‐dry reclaimed slopes derived from surface coal mining (the Teruel coalfield in central‐eastern Spain) showed a good field‐based performance. Therefore, we believe that this model is a valuable contribution for the management of water‐limited reclaimed systems, including those associated with rill erosion, as it provides a tool for the evaluation of restoration success and can play an important role in decision‐making during ecosystem restoration in severely disturbed landscapes. Copyright © 2011 John Wiley & Sons, Ltd.  相似文献   

Midnight reversal of ionospheric plasma bubble eastward velocity to westward velocity during geomagnetically quiettime: Climatology and its model validation     

José H.A. Sobral  Vivian M. de Castilho  M.A. Abdu  Hisao Takahashi  I. Paulino  Ulisses A.C. Gasparelo  Daniela C.S. Arruda  Matheus Mascarenhas  C.J. Zamlutti  C.M. Denardini  Daiki Koga  A.F. de Medeiros  R.A. Buriti 《Journal of Atmospheric and Solar》2011,73(11-12):1520-1528

In an effort to better understand the dynamics of westward velocities of the nocturnal F-region plasma, the climatology of the westward traveling plasma bubbles – WTB – occurring during quiettime is studied here. The climatology of the WTB is analyzed here based on airglow images obtained during 14 quiet days between 2001 and 2006 at the Brazilian station São João do Cariri (Geographic 7.45°S, 36.5°W, dip ～20°S). The frequency of occurrence of the WTB maximizes in the descending phase of the solar cycle. The WTB velocities ranged between ～20 and 40 ms^?1. The frequency of occurrence had a peak value of only 3.65% at 2345 LT. The maximum occurrence of the WTB was in July–September. No WTB have been observed from November until April in all years 2001–2006. We show for the first time theoretically that the WTB dominant forcing mechanisms during geomagnetically quiet days are westward thermospheric winds.  相似文献   

Performance of the Italian strong motion network during the 2009, L��Aquila seismic sequence (central Italy)     

Elisa Zambonelli  Rita de Nardis  Luisa Filippi  Mario Nicoletti  Mauro Dolce 《Bulletin of Earthquake Engineering》2011,9(1):39-65

On April 6, 2009, the town of L’Aquila in the Abruzzo region (central Italy) was struck by a seismic event at 01:32 (UTC), of magnitude M_W = 6.3. The mainshock was followed by a long period of intense seismic activity and within seven days after the mainshock there were seven events of magnitude M_W ≥ 5 that occurred from April 6 to April 13. This long seismic sequence was characterized by a complex rupture mechanism that involved two major normal faults of the central Apennines: the Paganica and the Gorzano faults. The strong-motions of the mainshock were recorded by 64 stations of the Italian Strong-motion Network (RAN) operated by the National Civil Protection Department (DPC). Six stations of a local strong-motion array were working in NW L’Aquila suburb area. One of them, located at about 6 km from the Paganica fault surface tip-line, set up in trigger mode, recorded continuously for more than 20 min the mainshock and the aftershocks. Besides the mainshock, the RAN stations recorded in total 78 foreshocks and aftershocks of M_L ≥ 3.5, during the period from January to December 2009. The corresponding waveforms provide the most extensive digital strong ground motion data set ever recorded in Italy. Moreover, the 48 three-component observations of events of magnitude M_W ≥ 5, recorded at a distance less than 15 km from each of the major involved faults, provide a significant increasing of near-field records available for the Italian territory. Six days after the mainshock, the strong-motion dataset, referred to preliminary locations of the events with M_L ≥ 4.0, was made available on the DPC web site () and at the same time it was delivered to the ITACA database (). This dataset has been used by many authors in scientific papers and by engineers, geophysicists and geologists for professional technical works. In this paper, the present-day available strong-motion signals from the L’Aquila sequence and the performance of the Italian strong-motion network in terms of the number and quality of recorded data, the geometry and data transmission system are described. In addition the role of the temporary network that represents an extension of the permanent Italian strong-motion network, supporting the emergency response by civil protection authorities and improving the network coverage has been evaluated.  相似文献   

Amplified exchange rate by tidal forcing of a piecewise-linear Helmholtz bay     

Jordy P. de Boer  Leo R. M. Maas 《Ocean Dynamics》2011,61(12):2061-2072

Sea-level and current measurements have been performed in the Mok Bay, a tidal embayment in the Dutch Wadden Sea, situated on the island of Texel, the Netherlands. Characteristic for this estuary is its nonuniform hypsometry. Oscillations in both water level and inflow of the estuary were observed, with characteristic frequencies of 31 and 48 cycles per day. The significant change in basin shape between low and high water is the cause for the existence of these two frequencies of resonance. Due to its semi-enclosed nature, the basin could at both tidal phases be characterized as a Helmholtz resonator, albeit of different dimensions. Depth measurements were performed to find these characteristic dimensions of the estuary, allowing the determination of its theoretical Helmholtz frequencies. These estimates match to within 10% with the observed frequencies, and this deviation can partly be explained. Although sea level oscillations at these frequencies have small amplitude (of order 1 cm), the accompanying oscillatory flow at the entrance is of similar magnitude as the tidal flow. The water level measurements (spanning only 8 days of data) were therefore modeled using a piecewise-uniform hypsometry that approximates the real hypsometric curve well. The simplified semi-analytical piecewise-linear viscous Helmholtz model captures the observed combination of tidal and eigenoscillations well. However, despite its simplicity, this model is able to display nonlinear behavior for certain parameter values. This is because of the intrinsic nonlinearity that accompanies the matching of the low and high water phases. In the setting studied here, bifurcations up to period 13 were found. This nonlinear type of response may be of importance in facilitating an extra exchange of sediments and nutrients between the Bay and the sea.  相似文献   

Preliminary results of a finite-element,multi-scale model of the Mahakam Delta (Indonesia)   总被引：1，自引：1，他引：0  

Benjamin de Brye  Sébastien Schellen  Maximiliano Sassi  Bart Vermeulen  Tuomas Kärnä  Eric Deleersnijder  Ton Hoitink 《Ocean Dynamics》2011,61(8):1107-1120

  相似文献   

Cotton Fiber/ZrO2, A New Material for Adsorption of Cr(VI) Ions in Water     

Alfredo Alberto Muxel  Sonia Maria Nobre Gimenez  Flaveli Aparecida de Souza Almeida  Rení Ventura da Silva Alfaya  Antonio Alberto da Silva Alfaya 《洁净——土壤、空气、水》2011,39(3):289-295

The natural cotton fiber was used to synthesize an anion exchange, containing ZrO₂ film on its surface, NCFZC (natural cotton fiber/ZrO₂ composite). This anion exchanger was produced by the reaction of the zirconium oxychloride and hydroxyl groups on surface of the natural cotton fiber. The material was used for Cr(VI) ions adsorption studies. Adsorption equilibrium time and optimum pH for Cr(VI) adsorption were found to be 6 h and 4.0, respectively. The Langmuir and Temkin isotherms were used to models adsorption equilibrium data. The adsorption capacity of NCFZC was found to be 1.33 mmol/g. Kinetic studies showed that the rate of adsorption of Cr(VI) on NCFZC obeyed a pseudo‐second‐order kinetic model.  相似文献